Rolling Capabilities

Plate Rolls

Our plate roller can handle 1 in. thick x 10 ft. wide mild steel. We have an additional cone rolling attachment when necessary as well.

Angle Rolls

Structural shapes: angles, bars, beams, channels and pipes are rolled using our two angle rolling machines. Our angle rolling capacity ranges from 1 x 1 x ⅛ in. up to 5 x 5 x ½ in. Special dies allow us to roll pipe as large as 3 in. Sch. 40, channels as large as 12 in. and beams up to 8 in.

Rolled Parts

Rolled Part - Cone flat made into 4 pieces—welded—then rolled to 7 ft.- 6 3/16 in. O.D. on the large end and 2 ft. 8 in. O.D. on the smaller end
Full screenExit full screen